[Chinese wardrobe network] [difficulties] A while ago, I bought a simple cloth wardrobe on the Internet. I finally received the goods today, but I don’t know how to install it, oh!
[Question] How to install cloth wardrobe?
ã€Best answer】
Check packaging
First of all, when receiving the goods, whether it is express or direct purchase, be sure to check whether the packaging is seriously damaged. If there is, it is likely that the steel pipe inside is also crushed. Such goods must not be signed and purchased. Check it clearly.
Check accessories
Open the package, and then check whether the accessories inside are complete. There is a manual, check the instructions. If there are few, it is estimated that you can't install it without using it. Therefore, the number of advances is clear, so as not to be wasted. When installing, be sure to wear gloves. And must read the instructions carefully.
First installed bottom
First install the bottom one, take out the four-way joint with the bottom and the high, and connect with the short tube in the middle. Install a four-way joint on each side, then install the tube on both sides, decide the position of the place, and install the long tube. Short tube. Then install the base cloth on both sides, then install a three-way joint around each Other.
Set of wardrobe sets
After installing the bottom, insert six short steel pipes, and then put the whole wardrobe cloth up against the surrounding holes. Then install a layer of partition like the bottom, and then put it on the six steel pipes.
Short-story floor
If the wardrobe is divided on two sides, first install the short-side floor, first insert the side steel pipe, then install the cloth, then connect the four-way joint, then install two horizontal steel pipes, then install the cloth, then Then make up the four-way joint on both sides. Repeat the baffle until it is attached to the top.
Long steel pipe
After the short-side partition is installed, the long side is a vertical hanging area, and a three-way joint is used to connect the two long tubes to the top.
Top steel pipe
After the two sides are installed, connect them directly with long steel pipes, so that the wardrobe is installed. If the wardrobe is too high and not enough to squeeze, it is recommended to push the side backwards so as not to be installed. At the same time, the hanging steel pipe can also be used. The connector is installed, this is relatively simple.
Set of wardrobe sets
When the top of the big set is at the top, it is best to pull the bottom to the top, so that there is space to pull on the top until the corners are installed diagonally. At this time, the cloth cover can be pulled down. The wardrobe is installed. After that, I feel that the whole wardrobe is so big. It is more than a small series, and it takes an hour to install it. As long as it is careful, it will not be wrong.
Other
Other,High Quality Other,Other Details, CN
DongGuan Sengtor Plastics Products Co., Ltd. , https://www.sentebio.com