Incorrect finishing work after the salt spray test will affect the results of the entire test, so it should not be a bit sloppy. Each of us should do our best to complete the finishing work after the experiment with a high sense of responsibility, and strive to draw a full stop for the entire experiment. The following is the operation steps after the end of the salt spray test box:
1. After the test, (the "Test End" indicator on the panel lights up) should first open the exhaust switch of the test room, the exhaust solenoid valve is energized, and compressed air is introduced to expel the salt spray from the test box Room, after about 15 minutes, exhaust completes turning off the machine power switch;
2. Then open the lid of the salt spray test box, and finally take out the sample to test the sample;
3. Discard the collected liquid in the measuring cup to prepare for the next test;
4. Drain the water accumulated in the gas-water separator at the inlet of the gas source. Operation method: push the thimble at the bottom of the gas-water separator by hand. After the water is completely drained, the gunman can reset the thimble.
Cooling Gym Towel,Quick Drying Sport Towel,Golf Waffle Towel,Best Gym Towel
Changshu Juhao Clean Textile Co., Ltd. , https://www.juhaoclean.com