How to place and use biochemical incubators

Shanghai Xinzhuang Instrument Co., Ltd. Xinzhuang (LNB) brand biochemical incubator is a two-way temperature regulation system with refrigeration and heating. The temperature is controllable. It is biological, genetic engineering, medicine, health and epidemic prevention, environmental protection, agriculture, forestry, animal husbandry, etc. The important test equipment of scientific research institutions, universities, production units or department laboratories in the industry, biochemical incubators are widely used in low temperature constant temperature test, culture test, environmental test and so on. The biochemical incubator controller circuit consists of a temperature sensor, a voltage comparator, and a control execution circuit.

Note on the use of biochemical incubators:

1. Install the biochemical incubator as much as possible in a place where the temperature and humidity change is small. Use a three-prong plug. The socket should be properly grounded.

2. Before starting the biochemical incubator, you should be familiar with and understand the instructions of each component and instrument, and master the correct use method.

3. It is strictly forbidden to contain volatile chemical solvents. Explosive gases and flammable gases are placed in the box. Do not use flammable sprays near the incubator to avoid spark ignition.

4, often check the gas path for air leakage.

5. The biochemical incubator has a power-off protection function, so it takes about one and a half minutes to start again after the compressor stops, so as to better protect the compressor.

6. The distance between the condenser and the wall of the biochemical incubator should be greater than 100mm, the side of the box should have a gap of 50mm, and the top of the box should have at least 300mm space to ensure good heat dissipation.

7. The biochemical incubator should avoid collision and shaking vibration during handling, maintenance and maintenance. The maximum inclination should be less than 45 degrees.

8. Turn off the main power supply and the power switch at the rear of the equipment when you stop using it for a long time. • At the same time, the biochemical incubator should avoid frequent door opening to keep the temperature stable while preventing dust and dirt from entering the work room.

9. The inside and outside of the box should be kept clean every day, and should be cleaned after each use. If you don't need it for a long time, you should always wipe the tank liner and equipment surface to keep it clean and increase the transparency of the glass. Do not use acid, alkali or other corrosive solutions to wipe the outer surface.

10. Turn off the power switch after the end of the culture. If the test sample is not taken out immediately, do not open the door.

11. The biochemical incubator should not be used under abnormal conditions such as high voltage, high current, strong magnetic field, etc., and strictly in accordance with the electrical safety operation rules.

Shanghai Xinzhuang Instrument Co., Ltd. Xinzhuang (LNB) brand biochemical incubator makes the experiment more stable, easier to operate, and more efficient. The main push SPX series biochemical incubator. The biochemical incubator sold by Shanghai Xinzhuang Instrument has reasonable price and stable function. Welcome new and old customers to consult and purchase!

Http://