Pressure and pressure of offset control center CP2000

Compression / pressure

1. Press the pre-selection to press/divide the print unit a. Press the Print function button (Figure 7-27/1) on the menu bar.

Printing function menu opens

(Figure 7-27 printing pressure / pressure control)

(Figure 7-28 Compression/disengagement of a printing unit)

b. Press one of the press or press (Figure 7-29/2) to make the selected printing unit press or press.

Another alternative method:

a. Select a print unit in the print function menu (Figure 7-27) (Figure 7-27/3). The print unit menu opens (Figure 7-28).
b. Press the press/discharge button (Figure 7-28/1).

2. Through the pre-selection to make several printing units at the same time pressure / pressure

a. Press the Print Unit Group button in the print function menu (Fig. 7-29/1). The print function/preview menu (Figure 7-29) is displayed on the display.
b. Press the press/discharge button (Figure 7-29/2). All printing units are pressed/separated at the same time.

When the machine is pressed, a white dot appears on the button.

Another alternative method: press the press/divider of several printing units on the print function menu.

 Tip: All settings only work after the machine has returned to production.

(Fig. 7-29 Simultaneous press/disengagement of printing unit)

3 manual pressure / pressure

If the machine is not under pressure, a setting will only work after the machine has returned to production. Sometimes, the machine is required to execute an order immediately, regardless of whether the machine is in operation (for example: pre-inking, pre-moistening). This can be done through the (Direct Operation Control) menu.

a. Press the Fault button on the menu bar (Figure 7-30/1) and press the Service button (Figure 7-30/2) in the (faulty) menu.

(Figure 7-30 manual pressure/pressure)

b. Press the Direct Operation Control button (Fig. 7-30/3) in the Service menu. The direct operation control menu appears on the display.
c. Use the printing unit button (Figure 7-30/4) to select the printing unit so that it is pressed/off. Press the Back button (Figure 7-30/5) to exit the menu.